Hyundai L&C high functional BODAQ BIO has three main functions.
Reduce harmful gas such as formaldehyde & VOCs which in Wall paper and plastic construction materials.
Make air fresh to reduce bad smell such as smoking and food smell.
Supply more far infrared ray to make customers healthy.
BODAQ Video & Installation Photo
Installation Video THAI
Installation Video THAI
Hyundai L&C
Hyundai L&C
The Proposal (Installation photo book)
The Proposal (Installation photo book)
Interior Film Installation Procedure
1. Preparation for Interior Film Installation
Check the condition of the type of surface which the interior film is to be applied before construction.
In the case of MDF, depending on the density if affects the adhesion and stability in construction.
Therefore, it is necessary to use MDF with uniform density.
Surface treatment operations should be aware of the following characteristics
Painted surface : It is necessary to remove the contaminants on the surface and proceed after the treatment of damaged surface.
Non-Painted surface : If the surface is rough, you should clean the surface with sandpaper first.
Prior to installation, check for any abnormality (product name, surface condition, flammability etc.) of the selected product.
When you build the site in weathers such as spring or autumn, or even during dawn, be sure to remove moisture that may remain on the wall.
Please keep the room temperature of the construction site at room temperature (15- 23) in order to remove moisture effectively.
Please keep in mind that when storing the product for a long time outside the packaging, it may cause cracking and weakening of the adhesives of the product. If there is a gas generation substance or a wax ingredient on the base material (adhered surface), please note that the adhesive may weaken.
2. Primer Treatment
The primer used in interior film construction shows the best performance and stability when using “BODAQ Primer” produced by Hyundai L&C.
MDF, PB and other woods have a very high absorption rate of primer due to the nature of the material. In case of the cut side, it should be applied 2-3 times.
It should be dried for at least 2 hours, and the interior film should be attached with an appropriate amount of force (pressure)